Add 2 quarts (1.9 liters) of the recommended oil. Reinstall the drain plug with the 6mm Allen socket and torque to 12 ft-lbs (16 Nm).ġ8. The sealing washer is part number 5812232.ġ7. The sealing surfaces on drain plug and crankcase should be clean and free of burrs, nicks or scratches. Install a new sealing washer on the drain plug. The oil filter for a RANGER 500 is part number 2540086.ġ6. Install the new filter and rotate it clockwise by hand until the filter gasket contacts the sealing surface, and then turn it an additional ¾ of a turn. Check to make sure the O-ring is in good condition.ġ5. Lubricate the O-ring on the new filter with a film of fresh engine oil. Ensure sure the old filter O-ring is completely removed.ġ4. Using a clean dry cloth, clean the filter sealing surface on the crankcase. Using the 2.5-inch (64mm) oil filter wrench, turn the filter counter-clockwise to remove it.ġ3. Caution: Hot oil can cause burns to skin. Remove the drain plug using a 6mm Allen socket. Tip: Place a rag in the bottom of the drain pan to prevent splashing of oil.ġ0. Place a drain pan beneath the engine crankcase. Allow it to warm up at idle for 2 to 3 minutes.ĩ.

Position the vehicle on a level surface in a well-ventilated area.ģ. To change the oil and filter, do the following:ġ. Access the drain plug from the bottom of the vehicle. The crankcase drain plug is located on the bottom of the crankcase. When changing the oil on your Polaris RANGER 500, always wear safety glasses and nitrile gloves. Always check and change the oil at the intervals outlined in the Periodic Maintenance Chart in your Owner's Manual. To learn more about tools, read the Tools and Fasteners Guide.

Polaris 350l 4x4 oil change